Already having the silicon header hose for my Wards header tank I asked the supplier if they could sell me a Stag set minus the two hoses I didn't need, this kit was delivered yesterday. Luckily just before I removed the old hoses I thought I'd check what I received, unfortunately one was missing, luckily it's the easiest to fit, the water pump housing to heater pipe one. I found the silicon hoses really easy to fit, a lot easier than getting the rubber ones on was. Unfortunately I couldn't get a 22mm hole saw locally to fit my level switch so I'll be syphoning a bit of coolant out again to get the header off on Tuesday when I'll have a saw, the fun never ends.
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. Registration to this Forum is open to Members of The Stag Owners Club (SOC) and Affiliated Overseas Clubs. Non members with an interest in the Triumph Stag may avail of a 30 day trial membership of the Forum. Details in the FAQ section. Registration is not necessary if you just wish to view the forums. To start viewing messages, select the forum that you want to visit from the selection below.