I have a 12 tonne press and can apply heat from a propane powered frame, will I be able to get the flanges off this way without warping the flanges?
Sujit
Sujit
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. Registration to this Forum is open to Members of The Stag Owners Club (SOC) and Affiliated Overseas Clubs. Non members with an interest in the Triumph Stag may avail of a 30 day trial membership of the Forum. Details in the FAQ section. Registration is not necessary if you just wish to view the forums. To start viewing messages, select the forum that you want to visit from the selection below.