I have rebuilt my water pump and upon reinstalling it I have noticed that the housing cover is fitting up to the block with no clearance. Even before I finger tight the 3 bolts the housing fits flush to the block. This doesn't seem correct.
Could the pump be too low in the block?
Any suggestions on how to proceed. My inclination is to install it with the thinnest of the three gaskets and hope for the best.
I'm a bit stumped...
-Michael Fatsi
Virginia, USA
Could the pump be too low in the block?
Any suggestions on how to proceed. My inclination is to install it with the thinnest of the three gaskets and hope for the best.
I'm a bit stumped...
-Michael Fatsi
Virginia, USA
Comment