I am taking a rover V8 out of my car and all except a few parts that can be used on a stag instalation are available. I am affraid the block has a small crack between two core plugs on right hand side and leaks water. May be able to repair. There are cut down SUs on the manifold and an exhaust manifold both sides that join a stag exhaust. The engine was running ok till the block cracked due to no antifreeze. Whoops. It still starts and goes to move car about. If you want any parts or all of it call Dave 07860424890 or email me. Whats it worth to you. dave-jell@supanet.com No bonnet bulge in my car.
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. Registration to this Forum is open to Members of The Stag Owners Club (SOC) and Affiliated Overseas Clubs. Non members with an interest in the Triumph Stag may avail of a 30 day trial membership of the Forum. Details in the FAQ section. Registration is not necessary if you just wish to view the forums. To start viewing messages, select the forum that you want to visit from the selection below.