If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. Registration to this Forum is open to Members of The Stag Owners Club (SOC) and Affiliated Overseas Clubs. Non members with an interest in the Triumph Stag may avail of a 30 day trial membership of the Forum. Details in the FAQ section. Registration is not necessary if you just wish to view the forums. To start viewing messages,
select the forum that you want to visit from the selection below.
Hi Guys,
got 8 alloy wheel nuts and 14 steel wheel nuts
they will all need repainting /polishing
any good?
Darren.Dont use alloy nuts you cant tighten them up enough,And they will come undone .Just ask Chris,Norfolk co,ordinator,His came undone some years ago.Derek Hicks
Last edited by Derek Hicks; 10 January 2016, 20:01.
Darren.Dont use alloy nuts you cant tighten them up enough,And they will come undone .Just ask Chris,Norfolk co,ordinator,His came undone some years ago.Derek Hicks
They will only come loose if they are either over tightened or the threads are damaged or worn. The car left the factory with them and wheel loss wasn't an issue then
Torque settings are specified for a reason.....................
Last edited by milothedog; 10 January 2016, 20:17.
Reason: Thought the Robsport Nuts were Alloy type
Wise men ignore the advice of fools, but fools ignore the advice of wise men sigpic
Comment