Routing of Loom past Heater Box

[rjahunter]

Can anyone help me with this. I can't work out where the main loom runs across from the relay plate on the LHS to the steering column, instruments etc on the RHS, It all looked fine until I tried to refit the heater box ! I can't work out where the loom should go relative to the box. Help please !

Richard

[StagnJag]

Does this help?

DSC_5871s.jpg

I can email you the full res version if you PM me your email address.

Rgds

Dave

[rjahunter]

That picture's fine thanks Dave. It confirms what I thought and where I had it before I tried to get the heater box back in ! I'll need to have another look. Thanks a lot for responding with such a good pic.

Richard

[rjahunter]

Finally got my heater box fitted today. The shaft which opens the face level air vent isn't very well attached to the control. Is there any better way to stop the control turning on the shaft ? The box itself was a right wrestle to get it into position for the bolts to fit through the bulhead, and then the drain tube has to go down through the hole at the front end of the transmission tunnel with a load of dum dum to (hopefully) stop it leaking from round there.

Also then got the loom routed over the box, with the large P-clips reattached to stop it moving.

Progress, but slow as always !

Richard

[Kevin Garrod]

Does this help?.
Dave

Dave I think you went beyond the call of duty to take that picture!!

[KOY 23]

dave i think you went beyond the call of duty to take that picture!!

:d:d:d:d

[KOY 23]

Dave I think you went beyond the call of duty to take that picture!!