EFI beather adivise

[Stagdad]

Hi Les ,my plenum is looking like it will be about 3.5L but i may be able to raise the base to reduce that and the inlet tracks are 240mm on the longest side so probably a bit shorter than yours.What makes you think yours are short?I guess the only way to make them longer is to go past each other and have them finishing nearer the opposite head like the outside pairs in a rover inlet.

Cheers Steve

[les M]

Steve
mine are 245 on the long side from the plenum to the back of the inlet valve, your's look alot longer than that? That's what I intend to do cross over the inlets and fit seperate plenum chambers ( well thats my plan)

Les.

[Stagdad]

Steve
mine are 245 on the long side from the plenum to the back of the inlet valve, your's look alot longer than that? That's what I intend to do cross over the inlets and fit seperate plenum chambers ( well thats my plan)

Les.

Ah measuring from different places,I measured from top of trumpet to head,no valves fitted but looks to be another 90mmish down to the top of where the valve would sit.Trumpet sits out of the sub base by 90mm.So add another 7mm for plenum base and gasket and that would make about 247mm from top of valve to plenum base.

Cheers Steve