Stag dash board gauges

[LONG UN 1]

HI CHAPS
i have replaced my dash borad after stripping off the pain to reveal the chrome on the clocks and seem to have a few issues
1 the petrol gauge has stopped working it has a supply live to it not sure if i have them the right way roun=d or its something else
also the temp gauge has decided to go mad it sits at half then goes into the red had the engine checked fine . was told the voltage stabiliser is not well .
not sure i have connected the wires rifght to it at the back .
all the gauges worked firn before i removed them ( dont they allways ) .
glad to have found somewhere that helps us keep these beutiful beasts on the road cheeers mart

[martin]

Hiya, welcome ! Get a solid state stabiliser, and new temp sender, probably £20 for both. Martin.

[singapore stag]

Hi, Maybe the coloured wiring diagram will help to see if the wiring has been "put on" the right way.

[LONG UN 1]

thanks for the info i have ordered a new volt stabiliser and sender from paddocks
i will look at the coloured drawing and see where i have gone wrong many thanks

cheers

[V Mad]

You have probably just lost the earth connection at the stabiliser. This causes the gauges to read too high.

[Colin Lambert]

My temp gauge reads low and takes ages to get there. But after a run the heat coming out from under the front wings is V.hot.
All other gauges work fine apart from clock which is knackered. Any ideas (perhaps no thermostat?)