Lumenition Distributor Module - Is This Wiring Correct?

[72BLUE]

A few spares came when I bought my Stag, I plan on fitting the Lumenition stuff supplied but wondered if this wiring is correct on the dizzy baseplate below?

Shoud the wires be under the baseplate as they do look to be a bit close to the 8 blade chopper???

Cheers, Keith.

IMG_1774.jpg

[72BLUE]

Bump

[Andrew S]

They look fine and are always on top rather that underneath. Make sure there is enough flex as teh base will twist under vacumn load.

[72BLUE]

They look fine and are always on top rather that underneath. Make sure there is enough flex as teh base will twist under vacumn load.

Cheers Andrew, many thanks for the reply!

Keith.

[stagmuffin]

also check that you fit the grommet on the cables where they enter the dizzy ,not fitted in your pic.they will chafe through and short otherwise i know as i had it happen.
steve

[72BLUE]

also check that you fit the grommet on the cables where they enter the dizzy ,not fitted in your pic.they will chafe through and short otherwise i know as i had it happen.
steve

Will do Steve, many thanks!