Stromberg Rebuild

[singapore stag]

Hi, I have decided to rebuild my Strombergs. Can anyone suggest where I should get the kit from....Ldparts, Paddocks, Rimmers, fleabay??? etc.
What do I require? or better still any dedicated rebuild threads on here?. They was one mentioned (thread) where I think some money was donated to the Mcmillan cancer trust (in appreciation for the info) but unfortunately I could not open the link, it dont seem to exist anymore...

Thanks, Sukh.

[KOY 23]

Hi Sukh.

I would go to LD parts every time, no idea of cost differences though, if they are more expensive I'm sure it's justified by quality and quantity of parts. I seem to remember that LD included choke housing gaskets that others didn't.

John.

[wilf]

Good carb info on buckeye triumphs, just remember the bits about the linkages are for a TR, not a Stag.

[AlanD]

Hi Sukh,

i sent the booklet out, pm your address and i will send you one FOC

alan

[singapore stag]

Hi Sukh,

i sent the booklet out, pm your address and i will send you one FOC

alan

Cheers Alan.....PM sent.

Sukh

[Guest]

Had enough of the Weber then Sukh?

[singapore stag]

Had enough of the Weber then Sukh?

Good set of Stroms lying about in the shed so thought I will use the winter to rebiuld them. Might use them again...who knows.

[Gresley]

Hi Sukh,

I bought my rebuild kit from Paddocks and I also bought new throttle spindles which were not included in the kit IIRC. I found it was a straightforward job but I stripped one carb at a time so that I had one for reference!

Brian.

[StagnJag]

I rebuilt my carbs several years ago now. I can't recall off hand who I bought the kit from, but it was a genuine Zenith Stromberg kit and had loads of bits in, including spindles, butterflies jet tubes and needles. It wasn't cheap, but I have had no problems with my carbs since. Probably 3 years now.

Rgds

Dave

[StagnJag]

These are the guys that make the genuine parts.

http://www.sucarb.co.uk/VehicleList.aspx?carManID=58&carModel=Stag&carYear=

Rgds

Dave

[Mike Stevens]

These are the guys that make the genuine parts.

http://www.sucarb.co.uk/VehicleList.aspx?carManID=58&carModel=Stag&carYear=

That's where I got the kit from this spring when I did mine (together with the rest of the car!)

Cheers,
Mike.

[PaterB]

...i rebuild my carbs recently using a rimmers kit. The zenith labeled- box contained everything i needed except needles and jets (which i didnt replace) only the included diaphragms were useless as they were way too stiff.