Steering heigh

[stonedrive]

Hi all,
changing ignition switch and harness, but the harness runs inside a metal plate, took four screws out but it won't drop because of the height adjusting bolt and lever, on steering column.Tryed nocking bolt out but it only moves a little then won't budge.Am I doing something wrong.
Many thanks Steve

[joel h]

hi Steve, i think there is a roller pin that you need to knock out. im sure someone will be on to give you more advice.
Joel.

[stonedrive]

Thanks for that Joel, now you mention it l think l can remember seeing a roller pin, but can't remember reading about it in Haynes manual.l shall try that tommorow, thanks again Steve.

[Ray Smith]

Thanks for that Joel, now you mention it l think l can remember seeing a roller pin, but can't remember reading about it in Haynes manual.l shall try that tommorow, thanks again Steve.

Hi Yes there is a roll pin you need to drift out, it is not mentioned in either Haynes or ROM! Have not found the need to replace on reassembly.
Ray

[stonedrive]

Cheers for that Ray. Steve