I have a small oil leak which is coming from where the gear selector leaver pivot enters the gearbox. There is a rubber seal according to the manual, but the strip down instructions are with the box out of the car. Does anyone know if the seal can be changed in position on the car?
-
-
yes it can.
seal might be available from
no connection
oh, also listed as 'RTC1704' by our 'speciallists'Last edited by jbuckl; 17 October 2016, 11:48. -
jbuckl - thanks very much for the feedback, however, I may not have been clear enough with the information I supplied. My leak is at the other end of the same shaft where the gear change lever is connected. I think the seal is RTC9A, but I am still not clear if this can be fitted in situ. I looks like it sits between the gearbox casing and the front servo. So if i am correct the servo has to be removed to fit the seal, but I don't know if this can be done on the car.Comment
Comment