Hi, Does anyone have a perspex Stag rear wind deflector for sale or one that they would be willing to me take the dimensions off to make my own.
Regards, Mike
Regards, Mike
-
-
imported post
Mike,
It's rather a difficult shape from which to give dimensions - curves and all that. I made a hardboard template before transferring it to the polycarbonate and drawing round it. I think that might be your best bet if you are going to make your own.
However, if you are near Bury, Lancs, you're welcome to borrow my template.
regards
Ray
-
imported post
Mike
Have a look at DJT's pictures in a recent post about home made deflectors
http://stagownersclub.mywowbb.com/vi...highlight=wind
Based on these I made a very adequate deflector for a fraction of the commercially available ones. If it's any help I just placed a piece of polycarbonate across the body tub just behind the B posts and literally drew a line from the centre of the caralong the line of the roll bar and the vertical B post. When I came to cut it I mirrored this shape on the other side and thenreduced it by about 5 cms all round. From memory the plastic is exactly48inches wide.
My first attempt had 2 vecro loops that went round the roll bar about 10 inches either side of thecentre line. I found the top corners vibrated too much at motorway speeds so I've 2 outer ones as well
David
Comment
Comment