Driveshafts

[tonypy1]

imported post

The Rilsan shafts came from me - my drive shaft supplier has produced hundreds of this type including competition 4x4 vehicles - the seal will work perfectly and last a very long time. Perhaps the seal would last longer than bellows....?

In terms of greasing the hub uj - just like any shafts with servicable ujs, the hub end would need to be removed.

Hope you enjoy your new twitch and clonk free handling!

[Guest]

imported post

Ah Tony, i'm very pleased with the driveshafts and, as you say, clonk and twitch free handling. Replacing the bushes on the trailing arms next.

I did think the seal would be OK, its just the original has bellows.

How tight should the seal cap be, i did them hand tight then half a turn with pipe grips, is this too much?

Thanks for the reply and info

Jason

[tonypy1]

imported post

Probably a bit much but I'm sure it will still be fine.

[Guest]

imported post

OK, i'll check them and probably back them off a touch

Jason