header tank

[alan230752]

imported post

picture uploaded now alan

[dripster]

imported post

A bit late to reply to this, but that looks very neat. Did you use the bracket from the TR7 or make your own?

Ian

[alan230752]

imported post

hi

it is standard tr7 bracket

alan

[GTJones]

imported post

Hi Guys

Fitted a Cosworth 2WD Header Tank - had the rad modified with a lower feed and also a M22 threaded joint for fitting the Thermo Switch for my Kenlow.

Works a treat - drops the System Pressure and now always run in the "E" at all external temperatures.










Lower Header Tank Feed back to Radiator

[Stagdad]

imported post

GT

Thats a great fit ,well done.

Cheers Steve

[singapore stag]

imported post

Hi GT, Whats the pressure rating on the cap ?, Does this tank have just the two outlets on it that you have plumbed into the top and bottom of the rad ?.

I think this tank looks much better then the square Volvo one I have.

Cheers,

Sukh.

[GTJones]

imported post

singapore stag wrote:

Hi GT, Whats the pressure rating on the cap ?, Does this tank have just the two outlets on it that you have plumbed into the top and bottom of the rad ?.

I think this tank looks much better then the square Volvo one I have.

Cheers,

Sukh.

Hi sukh

The Pressure rating is 18PSI so the hoses are not as hard as with the std 20PSI Cap - There is a Top feed as shown into the Radiator inlet and a lower feed to the bottom of the Radiator (Bottom of the Radiator on the Filler Side) This ensures that there is always a head of water above the pump & Thermostat so it avoid cavitation.

Regards

Gary