PDWA switch

[Arbman Al]

Hi Guys,

I ordered a PDWA switch from Paddocks the other day, thinking it would be the whole kit and caboodle - it wasn't

The part they (and it appears the other suppliers) supply is the part that screws into the brass body.

The connector on the end of the wire that clips to this bit does not come with the switch.

It is the connector part on my car that is broke, so my question is has anyone found a way of connecting the wire to the switch?

Rgds....Al.

[stustag]

imported post

Hi AL

If you mean the connector from the loom to the PWDA than yes get a female spade connector and open it slightly and it will fit over see pic.

Stuart

[stustag]

imported post

And finished.........

[Arbman Al]

imported post

That's the one Stu. Thanks.

The switch has two terminals, is there only one wire going in, and if so does it matter which terminal you connect it to?

Al.

[stustag]

imported post

Hi Al

You put the one wire into the connector then slide the connector over both terminals.

stuart

[Arbman Al]

imported post

I see what you mean, thanks Stu (again:dude

Al.