head light protectors

[stagman67]

just tryed to fit head light protectors but just can not seem to get the three clips rigth at all ,help anyone :X

[Andy Rundell]

imported post

I have them on mine and it took me a while to get i right - i started by thinking the clips would sit on the outside of the rim, the only way i could get them to sit well was to have the clips inside the rim and sprung to push outwards.

I have mine so that the grills fall diagonally rather than horizonal/vertical - this aligned better with the clips and i liked the way it looked.

There are probably other ways, but that is what i did.

.......Andy

[stagman67]

imported post

thanks andy i will have to have another go , i got them from rimmers but no fitting instructions

[Phil]

imported post

stagman67 wrote:

thanks andy i will have to have another go tomorrow , i got them from rimmers but no fitting instructions

Same here! first one fitted fine. The remaining three headlamps were all slightly different. There are various degrees of bend on all the remaining clips. Not sure how to remove them now and still be able to refit them:X

Phil

I think the word bodge probably applies here

[stagman67]

imported post

thanks phil yes bodge it might have to be :?