Master Cylinder Reservoir Seals

[Giles]

Hi

Does anyone know who sells the seals for the brake master cylinder reservoir where it bolts onto the top of thecylinder? - I am pretty sure this is where my leak is. If they are just O rings I still need to get the right thickness and know that they are brake fluid resistant. Cannot find them listed by the usual guys.

[sjm]

imported post

Hi Giles,

Wins international in surrey got some for me.

Steve

[stustag]

imported post

Hi Giles

I'm sure if you give any of the usual suppliers a call they will tell you what size O ring you need.

They will most likely have them in stock or once you have th esize nip down the local motor factors who will do them for about 10p each.

Stuart

[sjm]

imported post

stustag wrote:

Hi Giles

I'm sure if you give any of the usual suppliers a call they will tell you what size O ring you need.

They will most likely have them in stock or once you have th esize nip down the local motor factors who will do them for about 10p each.

Stuart

Not the usual type of O ring, best to get the right part for the job unless you want to take the paint off your inner wing.loland have to bleed the system down again.

Steve

[Dieter H. Marschall]

imported post

Hello,

I just rebuilt a master cylinder. The seal rings to the reservoir come with a square cross section. O-rings will be too thin anyway.

Good luck! Dieter.

[Giles]

imported post

thanksfor the advice- I will have to make some phone calls and get the right seals