Has anyone had any issue with standard brake discs / rotors from Rimmers? I'm in USA and their shipping rates to USA is the cheapest. One of my rotors has 0.013 inch of run-out and the ROM calls for no greater than 0.006 in.
Sujit
Sujit
-
-
2 years on and 2500 miles or so and mine are fine sujitTerry Hunt, Wilmington Delaware
www.terryhunt.co.uk -
Dimmers
Comment
-
Sujit, are you asking about Rimmer disks because you need new ones? Can’t you get the old ones turned? Are they thick enough?
Terry
Terry Hunt, Wilmington Delaware
www.terryhunt.co.ukComment
-
I had them turned at a local auto factor a few years back. I didn't check for run out at the time They are now smooth but have major run out. I'm going to do some experiments make sure they are sitting flat on the hub.Comment
-
look at the face between the disc and the hub. get it clean.
Make sure that the wheel bearings are set correctly
are you sure that the stub axle is in good orderStags and Range Rover Classics - I must be a loonyComment
-
I did some experiments yesterday. The highest and low spot is 180 degrees from each other. I made a mark with a sharpee. I then removed it from the hub and reattached 90 degrees off. I then re messured. The high and low spot is at the same spots on the rotor.Comment
Comment