Great article in Soc mag about diff pin mounts.
Think it’s been covered before, but very useful nevertheless.
Think it’s been covered before, but very useful nevertheless.
-
-
Filling up space? -
were all the posts helping you out then "Forum padding" ?
The answer isn't 42, it's 1/137Comment
-
Calm down chaps! It’s all helpful.Comment
-
NO! Only yours are truly helpful....honest.Originally posted by dasadrew View Postwere all the posts helping you out then "Forum padding" ?
46750265412_32ed6426ed_h.jpg
Last edited by singapore stag; 24 April 2022, 18:03.Comment
-
Yes, although I don't need the stud repair anymore, the magazine has really taken off over the past 1 or 2 years. Loads of technical stuff, and the archive finds too! I must admit that, a few years ago, it almost went straight into the bin after flicking through the N&N reports, but it's definitely coffee table content now!Originally posted by jbuckl View PostThe answer isn't 42, it's 1/137Comment
-
Has anyone got a drawing / sketch & material spec for the pin?Originally posted by dasadrew View Post
Not sure they are for sale at the moment. & I’m not cutting mine out to measure it!Comment
-
Bob has all that InfoOriginally posted by jbuckl View Post"The UK,s 2nd Most Easterly Stag" Quad Exhaust- ZF 4 Speed BOXComment
Comment