Weber Kick-down cable route

[KansasCityMilkman]

I'm in the process of fitting a Weber and I'm a bit concerned about the Kick-down cable resting against the cylinder head - could it melt the outer sheaf? Any tips (apart from refitting the Strommies!)?

[Staggering About]

I joined another cable to the existing one and routed it round the front of the carb.

[Phil S]

Mounting bracket looks like it's not allowing the cable anchor point to line up properly, make another to allow a good fit and then you will be able to cure the problem

[DJT]

If the cylinder head gets hot enough to melt the outer sheath, then you have real problems.

[KansasCityMilkman]

Thanks for the advice. The cable's not attached properly in the photo hence why it's not lined up - it was just a mock fitting. It's also a brand new cable so probably a bit stiff at the moment. Cheers guys.