Reversing light/Fog light conversion

[Cliff/Stag]

looking for wiring instructions to change reversing light bulb holder to double filament red & white reversing/fog

[SteveD]

Have a look at Grampianstags.net where there is a write up about this. http://www.grampianstags.net/

Steve

[Cliff/Stag]

Thank you Steve, I new I had seen it some where, must be an age thing, Cliff/Stag

[malc4d]

You will need to run a cable to the dashboard for the switch, the double filament and find a red / white bulb. If you want to use it as a second set of brake lights it will need some diodes.
I bought a kit from better car lighting.

[DJT]

The red/white LED from classiccarleds defaults to red, so if using it as brake/reverse light an additional relay will be required to ensure that they work as reverse lights when manoeuvring. I did discuss this with the owner of classiccarleds and he said he would look at possibly modifying the bulbs, but don't know if he did.

[gbb483]

You will need to run a cable to the dashboard for the switch, the double filament and find a red / white bulb. If you want to use it as a second set of brake lights it will need some diodes.
I bought a kit from better car lighting.

Grampian Stags avoids the use of diodes by putting in a relay.

[SteveD]

As I haven't got a hard top I used the heated rear window switch for the fog light control. I just fished the wire from the drivers side B post and extended it to the back of the car.

[Alacrity]

You will need to run a cable to the dashboard for the switch, the double filament and find a red / white bulb. If you want to use it as a second set of brake lights it will need some diodes.
I bought a kit from better car lighting.

Same here, but the most of my bulbs are from them. As DJT says I fitted a relay so the reverse lights stay on when the brake is applied, Better car lighting's setup gives you 4 brake lights & fog lights. I would suggest getting LED stop/tail bulbs while you are at it if not already done, make a big difference to most Stags.