Anyone know where I can get --

[alan_thomas]

Fitting my tubular exhaust manifolds and I needa set of exhaust gaskets where the centre 2 ports are separate not combined as in pic below. - Alan

[Guest]

imported post

Hi, as there's only one top bolt fixing does it make a difference ? Martin.

[Stagdad]

imported post

I asked this question a while back Alan.I fitted them in the end ,don't know if i'm loosing power because of them though.

Cheers Steve

[iani]

imported post

Stagdad wrote:

I asked this question a while back Alan.I fitted them in the end ,don't know if i'm loosing power because of them though.

Cheers Steve

Couldn't you make something up to fill the gap out of another gasket and seal it with some firegum?

Ian

[les M]

imported post

Alan

TR7 ones are what you need Robsport sell them about £10 for both heads
See Ebay for a pic item # 230475147453
Les.

[alan_thomas]

imported post

les M wrote:

Alan

TR7 ones are what you need Robsport sell them about £10 for both heads
See Ebay for a pic item # 230475147453
Les.

Cheers Les, I should have known this I played with TR7s for years. - Alan

Steve - Probably doesn't make much difference But I didn't fancy the hot gases blowing back and forward between the port every cycle.