If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. Registration to this Forum is open to Members of The Stag Owners Club (SOC) and Affiliated Overseas Clubs. Non members with an interest in the Triumph Stag may avail of a 30 day trial membership of the Forum. Details in the FAQ section. Registration is not necessary if you just wish to view the forums. To start viewing messages,
select the forum that you want to visit from the selection below.
Adjust the hinge on the opposite side to what you want to adjust, as you raise the bracket or lower it will level out the opposite side, have fun as it can be a B to get right.
Had the same thing myself after removing bootlid. Are you sure seal is seated all round, inc corners?
Suggest you take the seal off and check how lid is aligned - note that with lid up, the 2 pairs ofnuts, when loosened a little give you height adjustment for the leading edge at either side;can also adjust the gap to the panel between lid and hood cover. It's a matter oftrial and error I'm afraid, but pretty easy.
Comment