Stag EFi

[KOY 23]

Hi Steve.
Looks just like the Rover 25/45 stepper motor, I have a spare plug with a few inches of cable that I got from the scrappy with stepper motor. I fitted it to mine but did not work properly with the earlier MS software I was running. The idle screw in my plenum works fine. I am upgrading software and may have another go with the stepper motor.

[DJS]

impressive!

[alan_thomas]

My, my Steve you have been busy. When shall I deliver the engine crane to your place? - Alan

Fuel tank mods this weekend to finish off then a POR 15 sealer coating (not cheap but very tough)and I'm just waiting for a plug for my new idle control valve( trying a stepper motor this time)[ATTACH=CONFIG]36217[/ATTACH]

[Arbman Al]

Hi Alan,

Hope you are well mate?

Do you mean this engine crane?

Engine removal 4.JPGEngine removal 5.JPG

[Stagdad]

My, my Steve you have been busy. When shall I deliver the engine crane to your place? - Alan

<<<<< he means this one Al
Welcome back Alan, I may fit the kit to my existing engine thats in the car, but I'll be sure to give you a shout if I swap engines. Cheers