Rimmer Bros

[DJT]

indeed you can Bob but I and thomasalfie bought the link pipes made by Phoenix to connect to their manifolds - the lh one is too short and I believe it may be because they changed the length of the downpipe adaptor piece on the Lh side at some point and the lh link pipes Rimmers have which are made by Phoenix are too short. Just a possible answer.....

Cheers

Mike

Hi Mike,
What exhaust are you fitting it to? A new system, or the existing? If new, who is it made by? The Phoenix adaptors (supplied as a kit) are made to join to an existing system, which is cut to suit. Having visited the Phoenix factory and spoken to the MD, I can't imagine they have changed anything in the past 2 years as they know what they produced works. I went back to show them my car with their manifolds fitted.
I do know that they make them in batches to supply RB, JP and RS as required. I caught them just as they were about to make a batch of 24 and they just added another one on for me....
Dave

[Thomasalfie]

I got an email from Rimmers yesterday they have assured me that a new pipe should be with sometime next week. This has set me back in trying to get my car sunshine ready, annoying but not the end of the world I suppose. I am jury out on trusting Rimmers for further expensive purchases.. thanks all who responded.

[Tonyw]

I bought a prop shaft from RB and found when I fitted it two years later it was scrap (cv one) I contacted them and they said return it even though I had redrilled it. They couldn't refund me as it was over 22 months old but they did give me a credit for the full amount inc postage !! I thought that was excellent. Also bought many other parts with out any problems.

Tony

[mike@thenook]

Hi Dave,
last year I decided to replace the "cut down by me to fit" original front pipes with correct Phoenix ones to match the Phoenix manifolds i fitted about 10 years back - the lh one didn't fit (too short) so exchanged by Rimmers for another one which was long enough...

Cheers

[DJT]

Hi Dave,
last year I decided to replace the "cut down by me to fit" original front pipes with correct Phoenix ones to match the Phoenix manifolds i fitted about 10 years back - the lh one didn't fit (too short) so exchanged by Rimmers for another one which was long enough...

Cheers

OK Mike, glad you got it sorted...