imported post
stagmoneypit wrote:
Make one that fits, first time without any modifications. Don't care what it's made of as long as it's a faithful replica of Mr Triumph's original.
BTWI've a replacement from a major supplier sitting in theparts bin of shame. It didn't fit so I re o-ringed the orginal. It's too small to make a door stop.
stagmoneypit wrote:
Hi
I am looking into remanufacturing stag heater valves in the near future, do you think it would be worthwhile and if so does anyone have an original one available in good condition to use as pattern?
Stainless steel or brass?
Cheers Glen
(ANG Triumph)
PS Any other suggestions for remanufacturing projects from forum members would be very much welcomed!
I am looking into remanufacturing stag heater valves in the near future, do you think it would be worthwhile and if so does anyone have an original one available in good condition to use as pattern?
Stainless steel or brass?
Cheers Glen
(ANG Triumph)
PS Any other suggestions for remanufacturing projects from forum members would be very much welcomed!
BTWI've a replacement from a major supplier sitting in theparts bin of shame. It didn't fit so I re o-ringed the orginal. It's too small to make a door stop.
Comment